Treats 2,500L System
C300 Central Heating Cleanser 25L
25L Concentrate - treats a standard heating system up to 2,500L
Concentrated cleanser for removal of flux residue, scale and corrosion
Safety Data Sheets available upon request
So why use Cleanser for Old & New systems?
C300 Cleaner for is designed to target excess flux residues, greases, and oils in addition to installation debris and sludge.
passivates the metal surfaces and helps to prevent copper deposition, a
common cause of pinhole corrosion in radiators.
product should be added at the first filling of the system. The water
should then be circulated at normal operating temperatures for around 2
hours before being flushed out.
If you are using cold water, leave to circulate for 24 hours.
C300 Cleanser is designed for use without a powerflush machine
What if the system isn't new and only 6 months old?
a system has not been cleaned prior to use, all of the aforementioned
issues for new systems will be present, with the installation debris
causing issues and damage to the system.
Similar to new systems, Cleanser is designed to target installation and manufacture debris and contaminants.
When cleaned, it will passivate the metal surfaces and prevent copper deposition.
In this scenario, the system may benefit from a manual flush using with C600
With older systems the specific problems will dictate which cleaning chemical will give the best results
Older systems may need a much more thorough clean in order to break up, lift and suspend sludge build up
We would recommend using C400 Sludge Remover
for this purpose - it is the best central heating cleaner the job as it
breaks up, lifts and suspends sludge, allowing it to be flushed out of
the system with ease
If you are tackling circulation problems, identifiable as cold spots in radiators, most often caused by sludge build-up.
The formation of this sludge is almost impossible to completely prevent and it often settles in low flow areas of systems.