CredCardsTC
Sale!

C100 Central Heating Inhibitor

Inhibits corrosion, scale, hydrogen gassing, microbiological growth and boiler noise.

£5.84£431.09

C100 Central Heating Inhibitor

 

C100 Central Heating Inhibitor – Inhibits corrosion, scale, hydrogen gassing, microbiological growth and boiler noise.

For best results, systems should be cleansed and flushed with C300 in accordance with BS7593:2006

Safety Data Sheets available upon request

 

Why treat your heating system water?

All heating systems have two major substances: metal and water. Oxidisation (rust) may occur inside pipes, boilers and radiators. To have an efficient and healthy heating system this chemical reaction needs to be prevented. This is why a heating system inhibitor is used.

 

How do I add Inhibitor to my heating system?

Gravity Fed:

1. Turn off all components electrically in the system.
2. Turn off the water supply to the system via the F+E tank (feed and expansion) usually in the loft.
3. Find a drain point and drain the heating system.
4. Go back to the F+E tank and tip the required dose of Inhibitor into the tank. Most normal house heating systems with 10 – 13 radiators will only need one 1 bottle.
5. Re-fill and vent the heating system.

 

Pressurised:

1. Turn off all components electrically in the system.

2. Turn off the water supply to the system.

3. Find a drain point and drain the system.

4. CLOSE THE DRAIN OFF VALVE.

5. Select a radiator and close the valves at both ends.

6. Open the radiator bleed key and release any pressure.

7. Remove the radiator key completely and attach the inhibitor equipment to the radiator.

8. Whatever injecting equipment you use, there will be a plastic tapered insert that you screw into the radiator bleed hole.

9. Open the radiator valves and begin to inject the inhibitor.

10. Wait for few seconds to let some air into the radiator and gives you a chance to release any pressure without losing any inhibitor.

11. Close the radiator valves and release your injector. Replace the radiator bleed valve key.

12. Open the radiator valves and re-pressurise the system. Usually in most domestic houses it will be a cold pressure of .75-1.0 bar.

13. Turn on the components in the system

 

Even more of our products can be found here !

Be sure to check out our eBay and Amazon stores, too!

eBay allows you to see a varied range of products we provide.

Amazon is great for you to be able to view feedback from our other valued customers.

Weight N/A

Reviews

There are no reviews yet.

Be the first to review “C100 Central Heating Inhibitor”

Your email address will not be published.

I accept the Privacy Policy