CredCardsTC
Sale!

C100S Central Heating Super Inhibitor

Double the concentration of C100!

Inhibits corrosion, scale, hydrogen gassing, microbiological growth and boiler noise.

£8.09£728.99

C100S Central Heating Inhibitor

 

C100S Central Heating Super Inhibitor inhibits corrosion, scale, hydrogen gassing, microbiological growth and boiler noise.

 

Safety Data Sheets available upon request

 

How do I add C100S Central Heating Super Inhibitor to my heating system?

 

Gravity Fed:

1. Turn off all components electrically in the system.

2. Turn of the water supply to the system via the F+E tank (feed and expansion) usually in the loft.

3. Find a drain point and drain the heating system.

4. Close the drain point when your hose stops running.

5. Go back to the F+E tank and tip the required dose of Inhibitor into the tank. Most normal house heating systems with 10 – 13 radiators will only need one 1 bottle.

6. Re-fill and vent the heating system.

 

Pressurised:

There are two types of inhibitor injector for pressurised systems.

One is a hand pumped injector and the other is a pressurised aerosol can that injects automatically. The instructions below cover both applications.

 

1. Turn off all components electrically in the system.

2. Turn off the water supply to the system.

3. Find a drain point and drain the system. There will be some pressure but this will fall away.

4. Select a radiator and close the valves at both ends.

5. Open the radiator bleed key (a square pin situated at the top of the radiator) and release any pressure.

Use a bucket or towel to catch any water.

6. After the water has stopped, remove the radiator key completely and attach the inhibitor equipment to the radiator.

7. Whatever injecting equipment you use, there will be a plastic tapered insert that you screw into the radiator bleed hole.

8. Once the inhibitor injector is attached, open the radiator valves and begin to inject the inhibitor.

9. If you are using a hand pumped injector you should see when all the inhibitor has entered the system.

10. Wait for few seconds after the inhibitor has gone in. This is to let some air into the radiator and gives you a chance to release any pressure without losing any inhibitor.

11. Close the radiator valves and release your injector. Replace the radiator bleed valve key.

12. Open the radiator valves and re-pressurise the system. Usually in most domestic houses it will be a cold pressure of .75-1.0 bar.

13. Turn on the components in the system

 

Even more of our products can be found here !

Be sure to check out our eBay and Amazon stores, too!

eBay allows you to see a varied range of products we provide.

Amazon is great for you to be able to view feedback from our other valued customers.

Weight N/A

1 review for C100S Central Heating Super Inhibitor

  1. Martin Cherry (verified owner)

    Using this for years in bulk and it’s great. Does not show up on molybdate test strips but a correctly dosed system pH value should be 8.3 – 8.9.

Add a review

Your email address will not be published.

I accept the Privacy Policy